INSTALL (cont) - TM-9-2350-261-34

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
329

TM 9-2350-261-34 ‘7. 8. 9. 10. Apply a thin, even coat of primer and then N O T E sealing compound (item 68) to external Before you secure heater assembly tapered pipe threads of heater fuel inlet clamps, make sure there is at least 1 inch nipple (1) and adapter (2). Do not apply (3 cm) clearance between hull side wall primer or sealing compound beyond small and rear of heater assembly. end of threads. Install inlet nipple (1) adapter (2) in heater Install sleeve (4) and inlet hose (6). 11. , elbow (3), and assembly. 12. nut (5) on heater fuel 13. Connect fuel inlet hose (6) to adapter (2) on h e a t e r a s s e m b l y ( 7 ) . Place heater assembly (7) in clamps (8). Tighten clamps (8). Install two clamps (9) on fuel inlet hose (6). Secure to hull with two screws (10). Place heater elbow (11) and ground lead (12) on heater assembly (7). Secure with screw (13) and two washers (14). Install three other screws (13) and washers (14). GO TO NEXT PAGE 13-3

Privacy Statement
Press Release
Contact