48.
49.
50.
51.
52.
53.
Apply a thin, even coat of primer and then
sealing compound (item 68) to external pipe
threads of engine bulkhead elbow (1) and
transverse beam nipple (2). Do not apply
primer or sealing compound beyond small
end of threads.
Secure elbow (1) to power plant bulkhead
with nut (3).
Install sleeve (4) and nut (5) on heater fuel
inlet hose (6).
Connect fuel inlet hose (6) to elbow (1).
Disassemble bulkhead side of beam
nipple (2). Install nipple inl transverse
engine compartment beam with nut (7).
Install sleeves (8 and 9) and nuts
(10 and 11) on fuel hose (12).
54.
55.
56.
57.
TM 9-2350-261-34
Connect fuel hose (12) to elbow (1) and
beam nipple (2).
Install fuel hose (12) on personnel
compartment heater fuel line (13). Secure
with two strap assemblies (14).
Connect fuel line (15) to beam nipple (2)
and fuel pump adapter (16).
Install fuel line (15) on personnel
compartment heater fuel line (17) and
engine coolant heater fuel line (18), if
installed. Secure with nine strap
assemblies (14).
GO TO NEXT PAGE
13-7
