T M14.15.9-2350-261-34Remove and discard six screws (1), twocover plates (2), and plate gaskets (3) fromtop of carrier.Place two new gaskets (3), exhaustelbow (4), and intake elbow (5) on top ofcarrier. Secure with six new screws (1).W A R N I NGDrycleaningsolventP - D - 6 8 0 istoxicandflammable. Always use inan open area with good airflow, away from sparks,h e a t , o r f l a m e s . W e argoggles and gloves. Do not breathevapors. Avoid contact with skin, eyes, andclothes. If you get dizzy while usingsolvent, breathe fresh air and get medicalhelp. If solvent gets on hands, wash them.If solvent gets in eyes, flush eyes withfresh waterimmediately.nearby.and get medical helpKeep fire extinguisher16.17.18.19.20.21.Clean inside surface of intake hose (6) atone end only. Use dry cleaning solvent.Apply silicone adhesive sealant to cleanedinside surface of intake hose (6).Insert a 1 inch (3 cm) silicone rubberhose (7) into intake hose (6) until end ofhose (7) is flush with end of intakehose (6).Place a 30 inch (76 cm) intake hose (6)with large end on intake elbow (5) andreduced end on heater intake duct (8).Secure both ends with two clamps (9).Place exhaust duct (10) on exhaustelbow (4) and heater assembly exhaustoutlet (11).Install duct (10) in elbow (4) and exhaustoutlet (11). Secure with two U–bolts (12),saddles (13), four washers (14), and fournuts (15).13-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
