R E P A I R (cont) - TM-9-2350-261-34

R E P A I R (cont) - TM-9-2350-261-34_184

C H A P T E R 5 M A I N T E N A N C E O F C O O L I N G S Y S T E M

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
160

TM9-2350-261-34 8. Repair scuff or coating damage as follows: N O T E Do not use this repair if bladder has broken cords or fabric damage. W A R N I NG Dry cleaning solvent P - D 6 8 0 i s toxic and flammable. Always use in an open area with good air flow, away from sparks, h e a t , o r f l a m e s . W e ar gloves. Do not breathe vapors. Avoid contact with skin, eyes, and clothes. If you get dizzy while using solvent, breathe fresh air and get medical help. If solvent gets on hands, wash them. If solvent gets in eyes, flush eyes with fresh water and get medical help immediately. Keep fire extinguisher nearby. a. Clean about 1 square foot (0.09 square meter) around damaged area with dry cleaning solvent. b. Apply paint (see TM43-0139). W A R N I N G Air pressure in excess of 30 psi (207 sonnel. surized others. kPa) can injure per- Do not direct pres- air at yourself or Always wear gog- C. d. e. After.Mter the second coat of lacquer has dried, seal off bladder openings. Inflate Madder with 2–3 psi ( 14–21 kPa) compressed air. Apply a soap and water solution to repaired area. Look for bubbles that show leaks. Replace bladder that cannot be repaired. FOLLOW-THROUGH STEPS 1. Install Madder in carrier (see your -20). END OF TASK 4-19 (4-20 blank) goggles and

Privacy Statement
Press Release
Contact