TM 9-2350-261-20-2
8. Remove locknut (1) and screw (2) from
bracket assembly (3). Use cross-tip
screwdriver. Discard locknut.
9. Before removing screw (4), raise inner
transfer shaft (5) high enough to tilt the
outer transfer shaft (6).
10. Remove screw (4) and lockwasher (7) from
bracket assembly (3). Discard lockwasher.
11. Remove two screws (8), lockwashers (9),
nuts (10), and bracket assembly (3) from
power plant. Discard lockwasher.
I N S T A LL
NOTE
Lubricate rod end bearings before assem-
bling. Use GAA grease (see your LO).
13. Install bracket assembly (3) on power plant.
Secure with two screws (8), new
lockwashers (9), and nuts (10). Tighten
screws to 300-324 lb-in (34-37 N·m)
torque. Use torque wrench and socket
wrench set.
14. Install screw (4), and new lockwasher (7) in
bottom hole of bracket assembly (3). Tighten
screw to 264-288 lb-in (30-33 N·m) torque.
Use torque wrench and socket wrench set.
15. Position inner transfer shaft (5) and outer
transfer shaft (6) in bracket assembly (3).
Secure with screw (2) and new locknut (1).
Use crosstip screwdriver.
23-32
Change 1
