TM 9-2350-261-20-2
16. Install pin (1), washer (1.1) on bracket
assembly (2). Secure with new cotter pin
(3).
17. Install tee (4) on bracket assembly (2).
Secure with nut (5) and washer (6).
18. Connect fuel line (7) to tee (4).
19. Install throttle link (8) on bracket assembly
(2). Secure with new locknut (9) and
screw (10).
20. Install spring (11) and washer (12) on
throttle link (13). Insert throttle link
through pin (1) and secure with new cotter
pin (14).
21. Install governor throttle arm (15) on
governor (16). Tighten screw (17).
22. Install throttle link (13) on governor throttle
arm (15). Secure with screw (18) and new
locknut (19).
23. Adjust accelerator and transmission throttle
valve linkage (page 23-34).
FOLLOW-THROUGH STEPS
WARNING
Loose clothing is dangerous
around moving belts and
pulleys. You could get in-
jured if your clothes get
caught in moving parts.
1. Start engine (see your -10). Check that upper
accelerator linkage operates properly.
Stop/shutdown engine (see your -10).
2. Install power plant rear access panel
(page 24-27 or 24-29).
3. Raise and lock ramp (see your -10).
4. Stop/shutdown engine (see your -10).
END OF TASK
Change 4 23-32.1 (23-32.2 blank)
