TM 9-2350-261-20-2
R E P L A C E T O R S I O N B A R A N C H OR
D E S C R I P T I O N
This task covers:
Remove (page 22-36).
Clean, Inspect, and Replace (page 22-37).
Install (page 22-37).
INITIAL SETUP
Tools:
References:
General Mechanics Tool Kit (Item 30, App D)
See your -10
Socket wrench Set (Item 90, App D)
Torque wrench (Item 98, App D)
Equipment Conditions:
Carrier on level surface
Materials/Parts:
Engine stopped/shutdown (see your -10)
Cotter pin (2)
Carrier blocked (see your -10)
Preformed packing
Track shroud and covers removed (page 22-2)
Road wheel removed (page 22-7)
Personnel Required:
Torsion bar removed (page 22-32)
Unit Mechanic
Power plant removed (page 5–12) for second
torsion bar anchor, right side only
R E M O V E
1.
2.
3.
Remove two cotter pins (1) and pins (2) from
torsion bar anchor (3). Discard cotter pins.
Remove two screws (4) from anchor (3) on
fifth torsion bar anchors (M106A2, M1064,
and M125A2 only).
Remove anchor (3) and preformed packing (5)
from hull mount. Discard preformed packing.
M125A2, M106A2,
AND M1064 FIFTH
TORSION BAR ONLY
22-36
Change 2
