3. Remove plug (1) from road wheel support
arm (2). Use plug wrench.
6.
7.
8.
a.
b.
TM 9-2350-261-20-2
CAUTION
When removing or installing torsion bars,
the index or missing tooth on the anchor
end of torsion bar must align with index
on spline in road wheel arm, to allow bar
to pass through (page 22-34).
Pull torsion bar (3) from torsion bar anchor
(4). Use slide hammer on puller.
Remove puller and adapter from torsion bar.
If torsion bar (3) is broken, remove as
follows:
Remove road wheel end of torsion bar in
the same way as unbroken torsion bar.
Pull or drive end of broken bar from its
splined seat in torsion bar anchor (4).
4.
5
N O T E
Special socket head cap screw is used
with adapter.
Thread special screw through adapter.
N O T E
Screw is installed with head inside
adapter.
Thread adapter on puller, then thread
adapter with screw into torsion bar.
GO TO NEXT PAGE
22-33
