R E P L A C E T O R S I O N B AR

CLEAN, INSPECT, AND REPLACE - TM-9-2350-261-20-2_504

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
470

TM 9-2350-261-20-2 R E P L A C E T O R S I O N B AR D E S C R I P T I O N This task covers: Remove (page 22-32). Install (page 22-34). INITIAL SETUP Tools: General Mechanics Tool Kit (Item 30, App D) Adapter (Item 10, App D) Road Wheel Lifter (Item 39, App D) Puller (Item 48, APP D ) Socket Head Cap Screw (Item 62, App D) Plug Wrench (Item 92, App D) Torque Wrench (Item 96, App D) Materials/Parts: Grease (Item 18, APP c) Personnel Required: Unit Mechanic Helper (H) References: See your -10 See your LO R E M O VE 1. 2. W A R N I N G If road wheel lifter slips while lowering road arm, it could injure you. Stand clear before you lower road arm. With road wheel removed and road arm raised on lifter, start engine (see your -10). Place range selector in 1. Slowly drive earner forward off lifter so that road wheel support arm (1) hangs freely. Remove screw (2) from plug (3). Equipment Conditions: Engine stopped/shutdown (see your -10) Carrier on level surface Carrier blocked (see your -10) Track shroud and covers removed (page 22-2) Road wheel removed (page 22-7) Shock absorber removed from second or fifth road wheel (page 22-26) Remove power plant for first torsion bar, right side only (page 5-11) Driver’s front floor plate removed (page 24-44) for first torsion bar, left side only Power plant rear access panel removed (see your -10) for second torsion bar, right side only Driver’s rear floor plate removed (page 24-44) for second torsion bar, left side only Floor plates removed (page 24-37) for third and fourth torsion bar Mortar turntable tread plates open (M106A2 and M125A2 only) for fifth torsion bar (see your -10) 22-32

Privacy Statement
Press Release
Contact