TM 9-2350-261-20-2
REPLACE RIGHT FINAL DRIVE SHAFT
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Torque Wrench Adapter (Item 9, App D)
Vise (Item 76, App D)
Torque Wrench (Item 96, App D)
Materials/Parts:
Screw (16)
Self-locking nut (4)
Personnel Required:
Unit Mechanic
References:
See your -10
Equipment Conditions:
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Trim vane lowered and power plant front
access door open (see your -10)
R E M O VE
NOTE
Place gear range selector in neutral posi-
tion. Set or release differential steering
brakes as required to rotate or lock drive
shaft during removal and installation.
4. Remove yoke (4) from final drive (5).
5. Remove four locknuts (9) and adapter (10)
from differential (11). Discard locknuts.
6. Deleted.
INSTALL
1.
2.
3.
Remove eight screws (1) and washers (2)
from universal joints (3). Pry universal joints
loose and slide yoke (4) into final drive (5).
Discard screws.
7. Deleted.
8. Install yoke (4) in final drive (5).
Remove propeller shaft (6) with universal
joints (3) from carrier.
Position propeller shaft (6) in vise. Remove
eight screws (7) and washers (8) from
universal joints and shaft. Discard screws.
GO TO NEXT PAGE
Change 4
20-7
