TM 9-2350-261-20-2
REPLACE LEFT FINAL DRIVE SHAFT
DESCRIPTION
This task covers: Remove (page 20-5).
Install (page 20-6).
INITIAL SETUP
Tools
References:
General Mechanics Tool Kit (Item 30, App D)
Vim (Item 76, App D)
See your -10
Torque Wrench (Item 96, App D)
See your LO
Torque Wrench Adapter (Item 9, App D)
Materials/Parts:
Screw (16)
SeIf-locking nut (4)
Washer (16)
Personnel Required:
Equipment Conditions:
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Trim vane lowered be your -10)
Power plant front access door open
(see your -10)
Hull front access cover removed (page 24-24)
Unit Mechanic
Helper (H)
REMOVE
N O T E
Loosen accessible screws only enough to
relieve torque Move carrier to gain
access to remaining screws.
1.
2.
3.
4.
5.
6.
Remove eight screws (1) and washers (2)
from universal joints (3) and slide yoke (4)
into final drive (5). Discard screws and
washers.
Remove propeller shaft (6) with universal
joints from carrier.
Position propeller shaft (6) in vise. Remove
eight screws (7) and washers (8) from
universal joints (3) and shaft. Discard screws
and washers.
Remove yoke (4) from final drive (5).
Remove four locknuts (9) and adapter (10)
from differential (11). Discard locknuts.
Remove four lube fittings (12) from two uni-
versal joints (3), if required.
GO TO NEXT PAGE
20-5
