TM 9-2350-261-20-2INSTALL7. Deleted.8. Secure adapter (1) to differential (2) withfour new locknuts (3). Tighten nuts to75-80 lb-ft (102-108 N•m) torque. Usetorque wrench.11. Position propeller shaft (6) with universaljoints (7) and secure to differential (2) andfinal drive (6) with eight new screws (8)and washers (9). Tighten screws to 35-40lb-ft (47-54 N•m) torque. Use torquewrench and adapter. Loosen screws, thentighten again to 35-40 lb-ft (47-54 N•m)torque.9. Install yoke (4) in final drive (5).12. Deleted.NOTEWhen using torque wrench with torquewrench adapter, torque value must becorrected. Procedure for convertingtorque value is on page 2-32.10. Position propeller shaft (6) in vise and in-stall universal joints (7) with eight newscrews (8) and washers (9). Tighten screwsto 35-40 lb-ft (47-54 N•m) torque. Usetorque wrench and torque wrench adapter.Loosen screws, then tighten again to 35-40lb-ft (47-54 N•m) torque.FOLLOW-THROUGH STEPS1. Install hull front access cover (page 24-24).2. Close power plant front access doorbee your -10).3. Raise trim vane (see your -10).END OF TASK20-6Change 4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business