CLEAN, INSPECT, AND REPAIR - TM-9-2350-261-20-2

R E P L A C E B A T T E R Y B O X I N S U L A T I O N A N D H E A T E X C H A N G ER (M113A2, M741A1, M901A1, AND M1059 ONLY)

C H A P T E R 14 E L E C T R I C A L S Y S T E M M A I N T E N A N C E - W I R I N G H A R N E S S, R E C E P T A C L E , A N D C A B L E R E P A IR

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
331

5. 6. 9-2350 -261-20-2 If damaged, remove insulation sheet (1) from battery box cover (2). If damaged, remove insulation strip (3), front insulation sheet (4), rear insulation sheet (5), right insulation sheet (6), left insulation sheet (7), and bottom insulation sheet (8) from battery box (9). CLEAN, INSPECT, AND REPAIR 7. 8. 9. Clean heat exchanger plate with brush dipped in mixture of sodium bicarbonate. After foaming stops, flush with clean water and dry. Check heat exchanger. Replace bent or cracked heat exchanger. Check insulation. Replace loose, missing, or damaged strip or sheets. INSTALL 10. 11. If removed, install bottom insulation sheet (8), left insulation sheet (7), right insulation sheet (6), rear insulation sheet (5), front in- sulation sheet (4), and insulation strip (3) in battery box (9). 12. 13. 14. 15. 16. Apply sealing compound on sheets. Wait 10–20 seconds compound becomes tacky. insulation until sealing FOLLOW-THROUGH STEPS 1. Fill carrier cooling system (page 8–5). 2. Fill coolant heater system (page 32-10). 3. Start coolant heater (see your -10). Check heat exchanger for leaks. Turn heater off. If removed, install insulation sheet (1) on battery box cover (2). Install two new grommets (10) in battery box (9). Install two clamps (11) on heat exchanger (12). Install heat exchanger in battery box (9). Install two hoses (13) on heat exchanger (12). Secure with two clamps (11). On M741A1 carriers, install two short hoses (14) on heat exchanger (12). Secure with two clamps (11). Install two elbows (15) in hoses. Secure with two clamps (11). Place two clamps (11) on two hoses (13). Install hoses on elbows (15). Secure with clamps (11 ). 4. Raise and lock ramp (see your –10). 5. Stop/shutdown engine (see your -10). END OF TASK 13-38 TM

Privacy Statement
Press Release
Contact