TM 9-2350-261-20-2
REPLACE DISTRIBUTION BOX ASSEMBLY FOR 200 AMP
GENERATOR SYSTEM (M901A1 ONLY)
D E S C R I P T I O N
This task covers:
Remove (page 12-52).
Install (page 12-54).
I N I T I A L S E T UP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Materials/Parts:
Sealing compound (Item 52, App C)
Gasket
Grommet (8)
Lockwasher (4)
Lockwasher (5)
Personnel Required:
Unit Mechanic
References:
See your -10
Equipment Conditions:
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Battery ground lead disconnected (page 13-2)
Master switch panel assembly removed
(page 9-16)
R E M O V E
3.
1.
2.
Remove screw (1), lockwasher (2), circuit 6
lead (3), and cable assembly W8 leads (4 and
5) from bus bar (6). Remove circuit 6 lead
and grommet (7) from distribution box (8).
Discard grommet and Iockwasher.
Remove screw (9), lockwasher ( 10), circuit 10,
14, 15, 27E lead (11), and circuit 450A lead
( 12) from bus bar (6). Remove circuit 10, 14,
15, 27E lead and grommet (13) from
distribution box (8). Discard grommet and
lockwasher.
Remove screw (14), lockwasher ( 15), circuit
49 lead (16), and cable assembly W8 leads
(17 and 18) from bus bar (6). Remove circuit
49 lead, cable assembly W8 lead (19), and
two grommets (20 and 21) from distribution
box (8). Discard grommets and lockwasher.
12-52
