REPLACE RIGHT STOP LIGHT-TAIL LIGHT

Section II. MAINTENANCE OF WIRING HARNESS (M741A1 ONLY)

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
143

TM9-2350-261-20-2 REPLACE RIGHT STOP LIGHT-TAIL LIGHT INITIAL SETUP Tools: References: General Mechanics Tool Kit (Item 30, App D) See your -10 Materials/Parts: Equipment Conditions: Gasket Engine stopped/shutdown (see your -10) Lockwasher (2) Battery ground lead disconnected (page 13-2) Carrier blocked (see your -10) Personnel Required: Unit Mechanic REMOVE 1. 2. 3. Disconnect circuit 23 lead (1) and circuit 24 lead (2) from stop light–tail light leads (3). Remove two nuts (4), two lockwashers (S), stop light–tail light (5), and gasket (6) from carrier hull. Discard gasket and lockwashers. If needed, remove two studs (7) from rear of stop light–tail light (5). INSTALL 4. 5. 6. If removed, install two studs (7) in rear of stop light-tail light (5). Place new gasket (6) and stop light-tail light (5) on carrier hull. Secure with two new lockwashers (8), and two nuts (4). Connect circuit 24 lead (2) and circuit 23 lead (1) to stop light–tail light leads (3). FOLLOW-THROUGH STEPS 1. Connect battery ground lead (page 13-2). 2. Turn MASTER SWITCH ON. Operate main light switches to check that right stop light-tail light is operable. Turn all switches OFF (see your -10). END OF TASK 12-14

Privacy Statement
Press Release
Contact