INSTALL - TM-9-2350-261-20-2

REPLACE TRAILER LIGHT RECEPTACLE WIRING HARNESS (M741A1 ONLY)

REPLACE RIGHT REAR TURN SIGNAL WIRING HARNESS (M741A1 ONLY)

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
148

INSTALL 9. Install new gasket (1) on wiring harness (2). Feed through two holes in ramp. 10. Feed harness (2) through elbow (3), Install elbow (3) in bottom of ramp. 11. Install nut (4), spring (5), nut (6), and con- nector (7) on harness (2). Feed harness through hull. 12. 13. 14. 15. T M Install receptacle and cover four screws (9). Install four shells (10) and leads of harness (2). 9-2350-261-20-2 (8). Secure with washers ( 11) on Position ground lead (12) and clamp (13). Secure with two washers (14) and screw (15). Connect circuits 21, 23, 24, and 22-460-461 leads. FOLLOW-THROUGH STEPS 1. Connect battery ground lead (page 13-2). 3. Install rear floor plates (page 24-40). 2. Turn MASTER SWITCH ON. Operate stop 4. Raise and lock ramp (see your -10). light-tail lights and turn signals. Check that all lights are operable. Turn all light switches 5. Stop engine (see your –10). OFF (See your -10). END OF TASK 12-19

Privacy Statement
Press Release
Contact