REPLACE LEFT REAR TURN SIGNAL WIRING HARNESS (M741A1 ONLY)

REPLACE RIGHT SERVICE TAIL LIGHT WIRING HARNESS (M741A1 ONLY)

REPLACE TRAILER LIGHT RECEPTACLE WIRING HARNESS (M741A1 ONLY)

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
146

TM 9-2350-261-20-2 REPLACE LEFT REAR TURN SIGNAL WIRING HARNESS (M741A1 ONLY) INITIAL SETUP Tools: References: General Mechanics Tool Kit (Item 30, App D) See your -10 Materials/Parts: Equipment Conditions: Straps (6) Engine stopped (see your -10) Carrier blocked (see your -10) Personnel Required: Ramp lowered (see your –10) Unit Mechanic Battery ground lead disconnected (page 13-2) Rear floor plates removed (page 24-40 ) REMOVE 6. Connect circuit 23 leads (6) at left stop 1. 2. 3. light-tail light, trailer receptacle, and main Remove two screws (1), washers (2), and harness. guard (3) that secure wiring harness (4) to hull. Cut straps (5) that secure harness (4) to main wiring harness. Discard straps. Disconnect circuit 23 leads (6) at trailer re- ceptacle, left stop light-tail light, and main harness. Remove harness. INSTALL 4. 5. Route wiring harness (4) from center rear along carrier main wiring harness to upper left of carrier. Secure harness to the carrier main harness with new straps (5). Position guard (3) and secure with two screws (1) and washers (2). FOLLOW-THROUGH STEPS 1. Connect battery ground lead (page 13-2). 3. Install rear floor plates (page 24-40). 2. Turn MASTER SWITCH ON. Operate stop 4. Raise and lock ramp (see your –10). light-tail lights and turn signals. Check that all lights operate properly. Turn all light 5. Stop engine (see your -10). switches OFF (see your -10). END OF TASK 12-17

Privacy Statement
Press Release
Contact