REPLACE RIGHT SERVICE TAIL LIGHT WIRING HARNESS (M741A1 ONLY)

Section II. MAINTENANCE OF WIRING HARNESS (M741A1 ONLY)

REPLACE LEFT REAR TURN SIGNAL WIRING HARNESS (M741A1 ONLY)

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
145

TM 9-2350-261-20-2 REPLACE RIGHT SERVICE TAIL LIGHT WIRING HARNESS (M741A1 ONLY) INITIAL SETUP Tools: References: General Mechanics Tool Kit (Item 30, App D) See your -10 Material/Parts: Equipment Conditions: Strap (6) Engine stopped (see your -10) Ramp lowered (see your –10) Personnel Required: Battery ground lead disconnected (page 13-2) Unit Mechanic Carrier blocked (see your -10) Rear floor plates removed (page 24-40) 1. 2. Disconnect circuit 24 leads (1) at trailer receptacle wiring harness, main wiring har- ness, and right stop light-tail light. Cut straps (2) that secure wiring harness (3) to the main harness. Remove harness. Discard straps. 3. 4. Route wiring along carrier harness with harness (3) from center rear main harness. Secure to main new straps (2). Connect circuit 24 leads receptacle harness, right and rear main harness. (1) at trailer stop light-tail l i g h t, FOLLOW-THROUGH STEPS 1. Connect battery ground lead (page 13-2). 3. Install rear floor plates (page 2440). 2. Turn MASTER SWITCH ON. Operate stop 4. Raise and lock ramp (see your -10). light-tail lights and turn signals. Check that all lights operate properly. Turn all light 5. Stop engine (see your –10). switches OFF. END OF TASK 12-16 R E M O V E

Privacy Statement
Press Release
Contact