REPLACE TRAILER LIGHT RECEPTACLE WIRING HARNESS (M741A1 ONLY)

REPLACE LEFT REAR TURN SIGNAL WIRING HARNESS (M741A1 ONLY)

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
147

TM9-2350-261-20-2 REPLACE TRAILER LIGHT RECEPTACLE WIRING HARNESS (M741A1 ONLY) DESCRIPTION This task covers: Remove (page 12-18). Install (page 12-19). INITIAL SETUP Tools: References: General Mechanics Tool Kit (Item 30, App D) See your -10 Materials/Parts: Equipment Conditions: Gasket Ramp lowered (see your -10) Engine stopped (see your -10) Personnel Required: Carrier blocked (see your -10) Unit Mechanic Battery ground lead disconnected (page 13-2) Rear floor plates removed (page 24-40) REMOVE 1. Remove four screws (1) that secure receptacle and cover (2). 2. Remove screw (3), two washers (4), and clamp (5) that secure ground lead (6). 3. Disconnect circuit 21, 23, 24, and 22-460-461 leads. 4. 5. 6. 7. 8. Remove four shells (7) and washers (8) from wiring harness (9). Remove nut ( 10) and connector ( 11) from hull exterior. Pull harness (9) through hull. Remove spring (12) from harness (9). Remove nut (13) from elbow ( 14) and pull harness (9) from ramp. Discard gasket (15). Remove elbow ( 14) from bottom of ramp. 12-18

Privacy Statement
Press Release
Contact