TM 9-2350-261-20-2
REPAIR BLACKOUT HEADLIGHT
INITIAL SETUP
Tools:
References:
General Mechanics Tool Kit (Item 30, App D)
See your -10
Materials/Parts:
Equipment Conditions:
Lamp unit
Engine stopped/shutdown
Retaining clip (3)
Carrier blocked (see your
Personnel Required:
Unit Mechanic
(see your -10)
-10)
REMOVE
1.
3,
Loosen three screws (1). Pull retainer (2)
with lamp unit (3) away from light
housing (4).
Disconnect ground lead (5) and positive lead
(7) from housing (4).
Remove three retaining clips (6) and lamp
CLEAN, INSPECT, AND REPAIR
4. Check retainer and housing, replace blackout
headlight if any part is missing or damaged
(page 12-7).
INSTALL
5. Install new lamp unit (3) in retainer (2).
Secure with three new retaining clips (6).
6.
7.
Connect positive lead (7) and ground lead (5)
to light housing (4).
Install retainer (2) with lamp unit (3) and
three screws (1) on housing (4).
FOLLOW-THROUGH STEPS
1. Turn MASTER SWITCH ON (see your -10).
3. Turn all switches OFF (see your -10).
2. Turn blackout headlight switch ON to check
that headlight operates properly
(see your -10).
END OF TASK
12-10