TM 9-2350-247-20-2
REPLACE ENGINE EXHAUST PIPE GUARD (M548A1)
THIS WORK PACKAGE COVERS:
Removal (page 0208 00-1).
Installation (page 0208 00-2).
INITIAL SETUP:
Maintenance Level
References
Unit
See your -10
Tools and Special Tools
General Mechanic's Tool Kit (WP 0541 00, Item 57)
Materials/Parts
Equipment Condition
Lock nut (12)
Engine stopped (see your -10)
Personnel Required
Carrier blocked (see your -10)
Unit Mechanic
REMOVAL
1.
Loosen eight screws (1).
2.
Remove 8 screws (2), lock nuts (3), 16 washers (4), and slide guard (5) from exhaust pipe (6). Discard lock nuts.
3.
Remove four brackets (7) from four bracket clamps (8) by removing eight screws (1) and washers (9).
NOTE
Mark position of bracket clamps on exhaust stack before removing for later installation.
4.
Remove four bracket clamps (8) from exhaust pipe (6) by removing four screws (10), lock nuts (11), and eight washers
(12). Discard lock nuts.
