TURN SIGNAL LAMP, S TOPLIGHT OR CONTROL LIGHT DOES NOT LIGHT OR FLASH WHEN CONTROL IS IN RIGHT OR LEFT TURN POSITIONContinued

TURN SIGNAL LAMP, S TOPLIGHT OR CONTROL LIGHT DOES NOT LIGHT OR FLASH WHEN CONTROL IS IN RIGHT OR LEFT TURN POSITIONContinued - TM-9-2350-247-20-1_344

TURN SIGNAL LAMP, S TOPLIGHT OR CONTROL LIGHT DOES NOT LIGHT OR FLASH WHEN CONTROL IS IN RIGHT OR LEFT TURN POSITIONContinued - TM-9-2350-247-20-1_346

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
274

TM 9-2350-247-20-1 TURN SIGNAL LAMP, STOPLIGHT OR CONTROL LIGHT DOES NOT LIGHT OR FLASH WHEN CONTROL IS IN RIGHT OR LEFT TURN POSITION—Continued 0065 00 6Y 1. Install harness connector on turn signal control unit. 2. Remove bulb (1) from blackout marker light (2) (WP 0280 00). 3. Measure resistance of bulb (1) for continuity. 4. Does multimeter indicate any continuity? YES NO 6YN 1. Replace faulty bulb (WP 0280 00). 2. Verify no faults found. 7Y 1. Install bulb in blackout marker light (WP 0280 00). 2. Remove circuit 22 plug (1) from jack on left stoplight-taillight, or circuit 23 plug (2) from jack on right stoplight-taillight. 3. Turn MASTER SWITCH ON. 4. Turn main light switch lever on lighting control switch to BO MARKER. 5. Measure voltage between circuit 22 (left) plug (1) or circuit 23 (right) plug (2) and ground with both steering levers locked in parking brake position. 6. Does multimeter read less than 17 volts? YES NO 7YN 1. Turn MASTER SWITCH OFF. 2. Install circuits 22 and 23 on left and right stoplight-taillight. 3. Replace service stoplight or blackout bulb (WP 0276 00, WP 0275 00, or WP 0278 00). 4. Verify no faults found. 0065 00-5

Privacy Statement
Press Release
Contact