TURN SIGNAL LAMPS AND STOPLIGHTS DO NOT FLASH WITH CONTROL IN HAZARD POSITION

TURN SIGNAL LAMP, S TOPLIGHT OR CONTROL LIGHT DOES NOT LIGHT OR FLASH WHEN CONTROL IS IN RIGHT OR LEFT TURN POSITIONContinued - TM-9-2350-247-20-1_349

TURN SIGNAL LAMPS AND STOPLIGHTS DO NOT FLASH WITH CONTROL IN HAZARD POSITIONContinued - TM-9-2350-247-20-1_352

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
279

TM 9-2350-247-20-1 TURN SIGNAL LAMPS AND STOPLIGHTS DO NOT FLASH WITH CONTROL IN HAZARD POSITION 0066 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Multimeter (WP 0541 00, Item 29) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) MASTER SWITCH OFF (see your -10) T 1. Check for loose electrical connections. 2. Are all electrical connections clean and tight? YES NO TN 1. Clean and tighten faulty electrical connections. 2. Verify no faults found. Y 1. Remove harness connector from flasher (1). 2. Check continuity between pins A and C, and B and C. 3. Does multimeter read 0 ohms in both positions? YES NO YN 1. Replace flasher (WP 0509 00). 2. Verify no faults found. 0066 00-1

Privacy Statement
Press Release
Contact