TM 9-2350-287-20-1
8-2.
SHIFT CONTROL LINKAGE REPAIR (continued).
14.
Check to see that lever (39) is in neutral (N) position at transmission shift control lever index (79).
15.
Remove cotter pin (41), washer (40), pin (38), and assembled rod (29) from lever (39). Discard cotter pin.
16.
Loosen two nuts (44) on assembled rod (29).
17.
Adjust length of assembled rod (29), turning both bearings (43) to approximately 8 1/4 inches (20.57 cm), center-
to-center distance between bearings (43).
18.
Install assembled rod (29) in lever (39) with pin (38), washer (40), and new cotter pin (41).
19.
Tighten two nuts (44) against bearings (43) of assembled rod (29), checking witness holes (79) on bearings (43).
20.
Recheck to see that lever (39) is in neutral (N) position at index (79).
Change 1 8-16
