TM 9-2350-287-20-1
8-2.
SHIFT CONTROL LINKAGE REPAIR (continued)
8.
Remove cotter pin (10), washer (9), pin (12), and assembled rod (14) from bellcrank (63). Discard cotter pin.
9.
Check control base assembly (24) to make sure neutral safety switch (21) is in neutral (N) position. Verify by
trying to crank engine after fuel shutoff handle has been pulled (para 4-29).
10.
Loosen two nuts (44) on assembled rod (14).
11.
Adjust length of assembled rod (14), turning both bearings (43) until pin (12) can be installed easily into bellcrank
(63) and through bearings (43).
12.
Install washer (9) and new cotter pin (10) on pin (12).
13.
Tighten two nuts (44) against bearings (43) of assembled rod (14), checking witness holes (78) on bearings (43).
Change 1 8-15
