b. INSTALLATION - TM-9-2350-287-20-1

6-11. INLET THERMOSTAT AND HOUSING ASSEMBLY REPLACEMENT.

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
665

TM 9-2350-287-20-1 6-10. ENGINE COOLANT TUBE REPLACEMENT (continued). b. INSTALLATION WARNING Adhesives can burn easily, can give off harmful vapors, and are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in a well ventilated area; if adhesive gets on clothing or skin, wash immediately with soap and water. NOTE · Apply adhesive at connectors between hoses and mating tubes or castings. · Hoses must cover unpainted areas of tubes and fittings or be positioned evenly between red bands on tubes and housings. 1. Apply adhesive and install loop clamp (16) on engine coolant tube (14). 2. Apply adhesive and install engine coolant tube (14) in coolant pump hose (20), lower engine coolant hose (12), and bypass thermostat housing hose (11). 3. Apply adhesive and secure engine coolant tube (14) to engine with loop clamp (16), bolt (19), washer (18), new lockwasher (17), and nut (15). 4. Tighten hose clamp (13) at lower engine coolant hose (12) 5. Tighten two hose clamps (10) at bypass thermostat housing hose (11 ) 6. Apply adhesive and install surge tank tube (9) on nipple (22), and tighten hose clamp (23). 7. Tighten hose clamp (21) at coolant pump hose (20). 8. Apply adhesive and install radiator hose (5) on radiator (3). 9. Apply adhesive and install lower engine coolant tube (8) on radiator hose (5) and lower hose (7). Tighten two hose clamps (4) and hose clamps (6). 10. Apply adhesive and install hose (2) on lower engine coolant tube (8) and tighten hose clamp (1). FOLLOW-ON MAINTENANCE: Connect transmission oil cooler hose (para 8-5). Refill cooling system (refer to TM 9-2350-287-10). Install powerpack (para 3-2). Change 1 6-25

Privacy Statement
Press Release
Contact