f. ADJUSTMENT - TM-9-2350-287-20-1

ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT AND ADJUSTMENT (continued)+

ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT AND ADJUSTMENT (continued) - TM-9-2350-287-20-1_655

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
630

TM 9-2350-287-20-1 4-28. ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT AND ADJUSTMENT (continued). f. ADJUSTMENT NOTE Steps 1 through 7 cover adjustment of the engine throttle governor connecting link. 1. Remove quick-release pin (43) and connecting link (8) from bellcrank (15). 2. Loosen nut (29) on connecting link (8). 3. Fully depress accelerator pedal (62). 4. Push connecting link (8) toward rear of vehicle. 5. Adjust length of connecting link (8) by turning rod end (28) until quick-release pin (43) can be installed easily into bellcrank (15) and through rod end (28). 6, Release accelerator pedal (62). 7. Tighten nut (29) against rod end (28). Check whether witness hole (73) is closed after adjustment is complete by inserting small wire into hole. 4-98

Privacy Statement
Press Release
Contact