TM 9-2350-287-20-1
4-28. ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT
AND ADJUSTMENT (continued).
23.
24.
25.
26.
27.
28.
29.
Move transmission throttle control lever (7) against stop (toward bulkhead).
Loosen nut (29) on assembled rod (1).
Adjust length of assembled rod (1), turning rod end (28) until pin (80) can be installed easily into bellcrank (49)
and through rod end.
Release accelerator pedal (62) and remove pin (80).
Shorten assembled rod (1) by rotating rod end (28) two turns, compressing spring (6) slightly.
Tighten nut (29).
Install assembled rod (1), pin (80), and new Iockpin (81) in bellcrank (49),
FOLLOW-ON MAINTENANCE:
Install powerpack (para 3-2).
4-99