TM 9-2350-287-20-1
4-29. FUEL SHUTOFF ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
• General mechanic’s tool kit
(Item 24, Appendix 1)
Materials/Parts:
• Assembled washer screw (2) (Item 1,
Appendix H)
• Cotter pin (2) (Item 10, Appendix H)
• Lockwasher (3) (Item 175, Appendix H)
• Lockwasher (3) (Item 194, Appendix H)
Equipment Conditions:
• Vehicle parked on level ground (refer to
TM 9-2350-287-10).
• Air intake grille opened and secured
(refer to TM 9-2350-287-10).
• Drive& hatch cover opened and secured
(refer to TM 9-2350-287-10).
a.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
b.
1.
2.
REMOVAL
Remove quick-release pin (1) and clevis (23) from control arm (22).
Release S-hook (2) and chain (3) from cable (14).
Remove cotter pin (4) and clevis pin (5) from clevis (23). Discard cotter pin.
Remove cotter pin (11 ), straight pin (10), spring (9), washer (6), and pulley (7) from pulley bracket (8).
Separate pulley (7) from cable (14). Discard cotter pin.
Remove two assembled washer screws (13) and pulley bracket (8) from engine (12). Discard Iockwashers.
Remove three screws (18) and Iockwashers (17) from fuel shutoff plate assembly (16). Discard Iockwashers.
Remove fuel shutoff plate assembly (16) and attached cable (14) from vehicle.
Loosen nut (21) on fuel shutoff plate assembly (16) by backing it away from handle (1 9).
Remove handle (19) from cable (14).
Remove Iockwasher (20) and nut (21) from cable (1 4). Discard Iockwasher.
Remove two bearing halves (15) and cable (14) from fuel shutoff plate assembly (16).
INSTALLATION
Install cable (14) and two bearing halves (15) in fuel shutoff plate assembly (16).
Install nut (21 ) and new Iockwasher (20) on cable (14).
4-100
