TM 9-2350-287-20-1
4-28. ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT
AND ADJUSTMENT (continued).
b.
1.
2.
3.
4.
5.
DISASSEMBLY
NOTE
• Step 1 covers disassembly of assembled rods (13 and 18) equipped with two rod ends each.
• Step 2 covers disassembly of assembled rod (1), connecting link (8), and throttle rod assembly (32)
equipped with one rod end each.
• Step 3 covers further disassembly of connecting link (8) equipped with quick-release pin.
• Disassembly of connecting link (8) equipped with quick-release pin is shown in drawing.
Loosen two nuts (29) on two assembled rods
(13 and 18), and remove rod ends (28) and
nuts (29) from each assembly.
Loosen nut (29) on assembled rod (1),
connecting link (8), and throttle rod assembly
(32). Remove rod end (28) and nut (29) from
assembled rod (1), connecting link (8), and
throttle rod assembly (32).
Remove quick-release pin (43), chain (42),
and wire (41 ) from rod end (28) of connecting
link (8). Discard wire.
Remove spring pin (44) and two spring pins (48 and 50) from two pins (45 and 47). Discard spring pins.
Remove lever (51 ) and two pins (45 and 47) and bellcranks (15 and 49) from throttle bracket (46).
4-88
