TM 9-2350-287-20-1
4-28. ACCELERATOR, THROITLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT
AND ADJUSTMENT (continued).
c.
1.
2.
d.
1.
2.
3.
4.
CLEANING AND INSPECTION
Drycleaning solvent P-D480 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT use near open flame or excessive heat
Clean all metal parts except rod ends with drycleaning solvent and rag.
Inspect all parts for damage or excessive wear. Replace any damaged or worn parts.
ASSEMBLY
Install nut (71 ) and adjusting screw (72) on support (70).
Assemble throttle lever (69), two disks (68), and cover (67).
Install lever (26), accelerator pedal (62), collar (63), new spring pin (65), and two new spring pins (66) on shaft
(64).
Install bearing (61 ) and cap (58) in accelerator support (57) with two screws (60) and new Iockwashers (59).
4-90
