TM 9-2350-287-20-1
4-27. GLOW PLUG AND GLOW PLUG CONTROLLER REPLACEMENT (continued).
7.
Secure wiring harness (3) to engine with five clamps (7), washers (4), new lockwashers (5), and screws (6).
CAUTION
Install glow plug by hand. Do not use wrench. Hand-tightening glow plug will
ensure that glow plug is not cross-threading in engine. Failure to comply can
result in damage to equipment.
8.
Install glow plug (2) in engine. Turn glow plug (2) by hand to make sure it is properly threading into engine.
9.
Once glow plug (2) has been tightened by hand, use wrench to tighten glow plug (2) an additional one-half turn.
10.
Connect eight wiring harness connectors (1) to eight glow plugs (2).
FOLLOW-ON MAINTENANCE:
Install exhaust pipe (if removed) (para 5-2).
· Install air cleaner intake duct (if removed) (para 4-9).
[Follow-On Task Deleted]
Install front hull slope plate (if removed) (para 15-11).
Connect battery ground cables (para 7-42).
Change 1 4-83
