4-28. ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT AND ADJUSTMENT

FOLLOW-ON MAINTENANCE - TM-9-2350-287-20-1_641

ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT AND ADJUSTMENT (continued)

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
618

TM 9-2350-287-20-1 4-28. ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT AND ADJUSTMENT. This task covers: a. Removal b. Disassembly c. Cleaning and Inspection d. Assembly e. Installation f. Adjustment Initial Setup: Tools/Test Equipment: Lockwasher (5) (Item 177, Appendix H) General mechanic's tool kit (Item 24, Spring pin (Item 355, Appendix H) Appendix I) Spring pin (2) (Item 356, Appendix H) Spring pin (2) (Item 360, Appendix H) Materials/Parts: Spring pin (2) (Item 368, Appendix H) Dry-cleaning solvent (Item 28, Appendix D) Wire (Item 382, Appendix H) Rag (Item 56, Appendix D) Cotter pin (2) (Item 17, Appendix H) Equipment Conditions: Cotter pin (Item 19, Appendix H) Vehicle parked on level ground Cotter pin (5) (Item 37, Appendix H) (refer to TM 9-2350-287-10). Lockpin (Item 117, Appendix H) Powerpack removed (para 3-2). Lockwasher (8) (Item 175, Appendix H) a. REMOVAL WARNING Use care when removing spring. Spring is under tension and can act as a projectile when released and could cause severe eye injury. 1. Remove two cotter pins (2), three washers (3), spring (6), and assembled rod (1) from throttle control lever (7). Discard cotter pins. NOTE ·Remove throttle control lever from transmission shaft only if damaged or requiring replacement. ·If screw securing throttle control lever to transmission shaft is lost or damaged, notify Direct Support maintenance. 2. Remove screw (4), washer (5), and throttle control lever (7) from transmission. Install screw (4) and washer (5) in transmission. 4-84

Privacy Statement
Press Release
Contact