TM 9-2350-287-20-1
4-27.
GLOW PLUG AND GLOW PLUG CONTROLLER REPLACEMENT (continued).
b.
INSTALLATION
NOTE
If installing glow plugs only, perform steps 8 through 10.
1.
Connect wiring harness (20) to starter solenoid (21) with three nuts (18) and washers (19).
2.
Connect three hydraulic lines (16) at quick disconnects (17).
3.
Secure wiring harness (14) to engine with clamp (15).
4.
Install glow plug controller (8) on engine with two screws (12) and new lockwashers (13).
5.
Connect two electrical connectors (9 and 10) to glow plug controller (8).
6.
Connect wiring harness connector (11) to glow plug controller (8).
Change 1 4-82
