TM 9-2350-277-20-4
REPLACE RAMP LINKAGE (M113A3, M901A3, M981A3, AND M1059A3
ONLY)
0526 00
THIS WORK PACKAGE COVERS:
Removal (page 0526 00-1).
Installation (page 0526 00-3).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Torque Wrench (WP 0926 00, Item 85)
Materials/Parts
Cotter pin (3)
Key washer
Square washer
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
REMOVAL
NOTE
Some carriers are equipped with flat shaped ramp lock rods while other carriers are equipped
with hex shaped ramp lock rods. They are removed and installed differently, as described below.
NOTE
Removal and installation of ramp linkage is the same for both sides of carrier. Text is for one
side only.
1.
Remove cotter pin (1), headed pin (2), and connecting link (3) from arm (4). Discard cotter pin.
2.
Remove cotter pin (5), headed pin (6), and connecting link (3) from clevis (7). Discard cotter pin.
0526 00-1
