REPLACE RAMP LINKAGE (M577A3 AND M1068A3 ONLY)

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
387

TM 9-2350-277-20-4 REPLACE RAMP LINKAGE (M577A3 AND M1068A3 ONLY) 0527 00 THIS WORK PACKAGE COVERS: Removal (page 0527 00-1). Cleaning, Inspection, and Repair (page 0527 00-3). Installation (page 0527 00-3). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Cotter pin (6) Key washer (10) Locknut (4) Square washer Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) REMOVAL WARNING Falling ramp could cause severe injuries. Keep personnel clear of ramp area. 1. Remove cotter pin (1), headed pin (2), and clevis (3) from arm (4). Discard cotter pin. 2. Remove cotter pin (5), headed pin (6), and clevis (7) from lever (8). Discard cotter pin. 3. Remove two cotter pins (9), headed pins (10), and eyebolts (11) from arms (12)and (13). Discard cotter pins. 4. Remove eyebolt (11) from clevis (7). 5. Loosen two locknuts (14). Remove two adjusting screws (15) and locknuts from two hull brackets (16). Discard locknuts. 6. Remove eight screws (17), key washers (18), and four supports (19) with arm assembly from hull top plate. Discard key washers. 7. Remove locknut (20) and screw (21) from arm (4). Discard locknut. 8. Remove two screws (22) from connector (23). 0527 00-1

Privacy Statement
Press Release
Contact