TM 9-2350-277-20-4REPLACE RAMP LOCK LEVER AND CABLE (M577A3 AND M1068A3 ONLY) —Continued0525 004. Align clamp (7) with forward bulkhead weldnut. Secure with new lockwasher (6) and screw (5).5. Install two seal assemblies (1) on cable (2).6. Install two new locknuts (3) and joints (4) on cable (5). Secure joints with locknuts.7. Install two new locknuts (6) and clevises (7) on two joints (4). Do not tighten locknuts.8. Align spring (8) and catch (9) with lever (10). Secure with two new spring pins (11).9. Position arm (12) through bulkhead. Slide rear support (13) into place.10. Install key (14) on arm (12). Align lever (10) over key. Position front support (13) on arm.11. Place two supports (13) on hull top plate. Secure with four new key washers (15) and screws (16), bend keys on washersto secure.12. Install two screws (17), washers (18), and new locknuts (19) in lever (10). Do not tighten locknuts.0525 00-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business