TM 9-2350-277-20-4
REPLACE RAMP LINKAGE (M113A3, M901A3, M981A3, AND M1059A3 ONLY) —
Continued
0526 00
NOTE
Clevis (9) and one end of hex shaped rod (10) have left-hand threads.
3.
Remove clevis (7) from flat shaped rod (8), or clevis (9) from hex shaped rod (10).
4.
Remove cotter pin (1), four washers (2), headed pin (3), and latch (4). Discard cotter pin.
5.
Remove two screws (5), washers (6), and bracket (7) from hull top plate.
6.
Pull flat shaped rod (8) or hex shaped rod (9) from welded brackets on hull top plate. Remove three bumpers (10) as flat
shaped rod is removed, or three bushings (11) as hex shaped rod is removed.
7.
For hex shaped rod (9), bend back tabs on key washer (12), loosen jam nut (13), and remove clevis (14) from rod.
Remove jam nut from rod and discard key washer.
0526 00-2
