CHAPTER 5 MAINTENANCE PROCEDURES COOLING SYSTEM

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
78

CHAPTER 5 MAINTENANCE PROCEDURES COOLING SYSTEM CHAPTER OVERVIEW This chapter illustrates and describes maintenance procedures for: Procedures for removal, inspection, repair and installation of coolant manifolds and coolant pumps are contained in TM 9-2815-202-34. Section I Cooling Fan Drive Assembly and Universal Joints Section II Radiator Shroud and Vane Axial Cooling Fan Refer to TM 750-254 for repair of Cooling System. Assemblies Section III Surge Tank Section I COOLING FAN DRIVE ASSEMBLY AND UNIVERSAL JOINTS NOTE Repair of cooling fan drive assembly and univer- sal joints is direct support maintenance. UNIVERSAL JOINTS REPAIR NOTE Replace entire universal joint if any item is defective. R E M O V A L A Push skeeve joints (1 and 2) downward to remove from splin- ed shafts on fan gear boxes (3 and 4). B Pull universal joints (5 and 6) away from axial drive shaft assembly and up through opening in shroud. TA312530 5-1 Change 1 TM 9-2350-267-34

Privacy Statement
Press Release
Contact