CLEANING AND INSPECTION - TM-9-2350-267-34

COOLING FAN DRIVE ASSEMBLY REPAIR (CONTINUED) - TM-9-2350-267-34_103

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
83

5-6 Change 4 TM 9-2350-267-34 COOLING FAN DRIVE ASSEMBLY REPAIR (CONTINUED) CLEANING AND INSPECTION A B C D WARNING Dry-cleaning solvent (PD-680) is toxic and flammable. To prevent personal injury when using PD-680, use only in a well ventilated area. Avoid breathing vapors. If you become dizzy get fresh air immediately and seek medical attention. Avoid contact with eyes, skin, and clothing. Use protective goggles, gloves, and clothing. If contact is made, immediately flush with water and seek medical attention. The flashpoint for Type I dry-cleaning solvent is 100°F (38°C); for Type II it is 138°F (50ºC). Do not use near open flame or excessive heat. Clean all parts with dry-cleaning solvent before inspection. Inspect inner housing cover (8) for cracks or distortion. Replace if E cracked or distorted. F Inspect two retainers (14) for burrs, cracks or chips. Replace if burred, cracked or chipped. G Inspect bearing (19) and bearing (21) for damage or defects (TM 9-214). Replace if defective. Inspect sleeve (22) for cracks. Replace if cracked. Inspect spacer (20) for burrs or sharp edges. Replace if burred or defective. Inspect gear (39) for burrs, or cracked or broken splines. Replace if splines are cracked or broken. Remove burrs with fine file or stone.

Privacy Statement
Press Release
Contact