DISASSEMBLY - TM-9-2350-267-34

COOLING FAN DRIVE ASSEMBLY REPAIR (CONTINUED) - TM-9-2350-267-34_103

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
81

5-4 Change 4 TM 9-2350-267-34 COOLING FAN DRIVE ASSEMBLY REPAIR (CONTINUED) DISASSEMBLY A Remove two screws (6), gasket (7), and inner housing cover (8) from cooling fan drive assembly (3). Discard gasket. B Remove preformed packing (9) from inner housing cover (8). Discard preformed packing. C Remove four screws (10), two bevel gear assemblies (11), two shims (12), and two preformed packings (13) from cooling fan drive assembly (3). Discard preformed packings. • There are two bevel gear case assemblies. Both assemblies are disassembled in the same manner. This task disassembles only one bevel gear case assembly. Perform steps D through H for disassembly of bevel gear case assembly. D E F G H Remove retainer (14) from bevel gear case assembly (11). Remove preformed packing (15) and seal (16). Discard preformed packing and seal. Straighten locking tabs on key washer (17). Remove nut (18) and key washer (17). Discard key washer. Remove bearing (19), spacer (20), bearing (21), and sleeve (22) from gear shaft (23).

Privacy Statement
Press Release
Contact