7-30Change 2TM 9-2350-267-34TORSION BAR ANCHORS FOR ROADWHEEL 3: REMOVAL, CLEANING AND INSTALLATION (CONTINUED)CLEANINGWARNINGDry-cleaning solvent (PD-680) is toxic and flam-mable. To prevent personal injury when usingINSTALLATIONPD-680, use only in a well-ventilated area. Avoidbreathing vapors. If you become dizzy, get freshAInstall torsion bar anchor (6).air immediately and seek medical attention. Avoidcontact with eyes, skin and clothing. Use protec-BInstall two screws (4) and four flat washers (5).tive goggles, gloves, and clothing. If contact ismade, immediately flush with water and seekCTorque screws (4) to 245 ± 15 lb-ft and install new locking wiremedical attention. The flashpoint for Type I dry-(3).cleaning solvent is 100°F (38°C); for Type II it is138°F (50°C). Do not use near open flame or ex-NOTEcessive heat.Apply sealing compound (item 65, Appx B) aroundA Clean cover plate (2) and hull floor.entire edge of cover plate.BClean torsion bar anchor cavity in hull. Remove dirt and water. DPosition cover (2) on floor of hull at crew compartmentDry thoroughly.bulkhead. Aline mounting holes. Secure with eight screws (1).TA57385
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business