assembly - TM-9-2350-267-34

CHAPTER 8 MAINTENANCE PROCEDURES: PERSONNEL AIR DUCT VENTILATING FAN

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
166

7-32 Change 1 T M 9 - 2 3 5 0 - 2 6 7 - 34 TRACK ADJUSTER: DISASSEMBLY AND ASSEMBLY (CONTINUED) A B c D E F G H I J If bearings (11) were removed in step J use arbor press (item 1, Appx D) and install new bearings. Coat inside of cylinder (1) with grease (item 25, Appx B). Place cylinder (1) in vise. Install lubricating fitting (10) in cylinder (1). Install new packing (9) and new wiper ring (8) in nut (2). Install new packing (7) and two new retainers (6) on piston (5). Coat surface of piston (5) with grease (item 25, Appx B) and slide piston (5) into cylinder (1). Install bleeder body (4) and bleed plug (3) in cylinder (1). Push nut (2) over end of piston (5) and install in end of cylin- der (1). Remove track adjuster from vise.

Privacy Statement
Press Release
Contact