TORSION BAR ANCHORS FOR ROADWHEEL 3: REMOVAL, CLEANING AND INSTALLATION

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
163

TORSION BAR ANCHORS FOR ROADWHEEL 3: REMOVAL, CLEANING AND INSTALLATION Test Equipment/Special Tools Torque wrench, 0-600 lb-ft (item 25, Appx D). Materials/Parts: Dry-cleaning solvent (item 18, Appx B) Sealing compound (item 65, Appx B). Wire, non-electrical Equipment Condition: PowerPack removed (TM 9-2350-267-20). Fuel tanks removed (p 4-10). Torsion bar removed (See TM 9-2350-267-20). A Remove eight screws (1) securing cover plate (2) to floor of hull at crew compartment bulkhead. B Cut locking wire (3), remove and discard. C Remove two screws (4) and four flat washers (5) from each tor- sion bar anchor (6). D Remove torsion bar anchor (6). 7-29 Change 2 TM 9-2250-267-34

Privacy Statement
Press Release
Contact