IDLER ARM ASSEMBLY REPAIR (CONTINUED)

IDLER ARM ASSEMBLY REPAIR (CONTINUED) - TM-9-2350-267-34_186

IDLER ARM ASSEMBLY REPAIR (CONTINUED) - TM-9-2350-267-34_188

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
159

IDLER ARM ASSEMBLY REPAIR (CONTINUED) N O P Q R Inspect idler arm (19) for damage or defects. Replace if damag- ed or defective. Check OD of inner sleeve bearing journal (A). OD (A) of new part is 3.0000-3.0010 inches. Wear limit is 2.990 inches. Check OD of outer sleeve bearing journal (B). 013 (B) of new part is 4.2500-4.2510 inches. Wear limit is 4.2490 inches. Check ID of inner sleeve bearing bore (C). ID (C) of new part is 3.5003-3.5013 inches. Wear limit is 3.5020 inches. Check ID of outer sleeve bearing bore (D). ID (D) of new part is 4.3755-4.3770 inches. Wear limit is 3.2780 inches. S T U V Refer to TM 9-214 for inspection of inner sleeve bearing (11). Check OD (E) of bearing (11). OD (E) of new bearing is 3.4920- 3.5020 inches. Wear limit is 3.4900 inches. Check ID (F) of bearing (11). ID (F) of new bearing is 2.9960- 3.0100 inches. Wear limit is 3.0120 inches. Check fit of inner sleeve bearing. New part fit is 0.0070- 0.0140L. 7-25 Change 1 TA312562 TM 9-2350-267-34

Privacy Statement
Press Release
Contact