DRIVE END SECTION ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION

CONVEYOR HINGE ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION

DRIVE-END SECTION ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION (CONTINUED)

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1018

12-24 TM 9-2350-267-20 DRIVE END SECTION ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION REMOVAL A Remove conveyor assembly from vehicle (p 12-27). B Remove conveyor chain assembly (TM 9-2350-267-10). C Remove electrical wiring harness (p 6-121). D Remove dead-end section from drive-end section (p 12-12). E Remove three nuts (1), three lockwashers (2), three flat washers (3) and three screws (4) from two hinge halves (5). NOTE Allow hinge halves to remain secured to center sec- tion (6). F Release toggle clamps (7) and disconnect tube assembly (8) from safety hooks (9) and remove drive-end section from conveyor assembly. TA310224

Privacy Statement
Press Release
Contact