12-26
TM 9-2350-267-20
DRIVE-END SECTION SIDE WEAR STRIPS, CHAIN RETURN WEAR STRIP, BOTTOM WEAR STRIP, CHAIN GUARDS:
REMOVAL AND INSTALLATION
REMOVAL
Do not remove chain from around take-up end
section.
A Remove chain assembly from work area (TM 9-2350-267-10).
B Remove 10 screws (1) from each side wear strip (2). Pry up and
remove wear strips from drive-end section (3).
C Remove two screws (4), wear strip (5) and spacer (6) from con-
veyor section.
D Remove 16 screws (7) and bottom wear strip (8).
E Remove chain guard (9) by removing from each, six screws (10),
six flat washers (11), six lockwashers (12), six nuts (13) and re-
taining strip (14).
INSTALLATION
A Reverse order of removal procedures.
B Thoroughly clean wear strip mounting surface of section (3) with
solvent (item 19, Appx D) and clean, dry rags (item 50, Appx
D). Remove all particles.
C Roughen underside surface of wear strips (2). Apply adhesive
(item 1, Appx D) to roughened side of wear strips (2) and moun-
ting surface of section (3). Allow to dry until tacky before in-
stallation. Apply sealing compound (item 53, Appx D) to
threads of screws (1).
TA310226
