12-20
TM 9-2350-267-20
CONVEYOR TOGGLE CLAMP AND TUBE ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION
WARNING
Do not attempt to remove or release both tog-
gle clamps at the same time. Conveyor could col-
lapse and cause injury to personnel.
A Raise toggle clamp handle (1) to release tension on tube
assembly (2). Remove tube eye from hook (3).
B
Remove six screws (4) and toggle clamp (5) from conveyor center
section (6).
c
Remove screw (7), flat washer (8), lockwasher (9) and tube
assembly (2).
DISASSEMBLY
A Remove screw (10), nut (11), lockwasher (12), flat washer (13)
and hook (3),
B Turn out and remove clevis (14) from toggle assembly (5).
C Remove screw (15), flat washer (16) and remove clevis (17) and
brace (18) from rod end (19).
D Back off jam nut (20) and remove rod end (19). Remove jam nut
(20) from tube assembly (2).
REMOVAL
ASSEMBLY
Reverse order of disassembly procedures.
NOTE
INSTALLATION
The following procedures apply to both toggle clamps
and tube assemblies.
Reverse order of removal procedures.
TA310220
