CONVEYOR HINGE ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION

CENTER SECTION ASSEMBLY SIDE WEAR STRIPS, CHAIN RETURN WEAR STRIP AND BOTTOM WEAR STRIP: REMOVAL AND INSTALLATION

DRIVE END SECTION ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1017

CONVEYOR HINGE ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION I WARNING I I Do not remove more than one hinge at a time. Conveyor could collapse and injure personnel. Do not operate or stow conveyor with hinge removed. I NOTE The following procedures apply to all four hinge assemblies. NOTE Do step A for left side hinge removal only. Otherwise start at step B. REMOVAL A Remove cable clamps (1) on both sides of hinge by removing from each, one screw (2), one lockwasher (3) and one flat washer (4). B Remove six nuts (5), six lockwashers (6), six flat washers (7) and six bolts (8). C Remove hinge assembly (9) from conveyor sections. A Loosen setscrew (10) and drive out hinge pin (11). B Separate hinge halves (12 and 13). Reverse disassembly procedures. INSTALLATION Reverse removal procedures. TA310223 12-23 TM 9-2350-267-20

Privacy Statement
Press Release
Contact