CONVEYOR ASSEMBLY AND SUPPORT STAND: REMOVAL AND INSTALLATION

DRIVE-END SECTION SIDE WEAR STRIPS, CHAIN RETURN WEAR STRIP, BOTTOM WEAR STRIP, CHAIN GUARDS: REMOVAL AND INSTALLATION

CONVEYOR ASSEMBLY AND SUPPORT STAND: REMOVAL AND INSTALLATION (CONTINUED)

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1021

TA310227 CONVEYOR ASSEMBLY AND SUPPORT STAND: REMOVAL AND INSTALLATION REMOVAL A B C D E NOTE This procedure will require four personnel. Remove springs (1) (p 12-6). WARNING Be careful when deploying conveyor without springs attached. Deploy slowly. Deploy conveyor slowly but do not attach support arms (TM 9-2350-267-10). Place support under conveyor. Disconnect electrical wiring harness connectors at drive-end sec- tion and remove harness and clamp from support stand (p 6-121). Disconnect hydraulic lines (2) from conveyor motor (3). 12-27 TM 9-2350-267-20

Privacy Statement
Press Release
Contact